新闻中心

当前位置: 网站首页 -

Points for Attention in Maintenance or Replacement of New Braiding Machine Parts

Writer:徐州恒辉Source:徐州恒辉编织机械有限公司 Number of visits: Date:2019-09-18
The precise distance between the sliding seat and the lower spindle braiding line must be ensured when some parts of the knitting machine, such as spindle bracket and sliding seat, are repaired and disassembled or when new parts are replaced and reassembled. It is suggested that a sliding frame and its upper ingot should be placed first to run on the sliding turntable so that the lower anchor braiding line can not be hooked or cut off by the sliding frame when leading from the pendulum bar to the braiding point.
 
When roughing, the spindle is placed on two adjacent external ingot brackets, and the knitting line is directed to the knitting point through the pendulum rod, and the knitting line is folded tightly. When the braiding line enters or exits from the slot on the sliding disc track, the distance from the braiding line to the edge of the upper ingot sliding frame must be basically equal. Distance adjustment can be achieved by changing one or more gears forward or backward of the gear rack. If moving a tooth can not reach the precise adjustment distance, the following steps can be taken to fine-tune: loosen the five fixed screws on the inner gear ring, because of the ellipse when through the hole, the sliding frame can be fine-tuned by moving the inner gear ring, and tighten the screw after the adjustment is in place. If the swing height of the braided line of the new swing bar is different after installation, it should be adjusted to the same stop point of all swing bars.
 
1. Check whether the lubricating oil in the braiding machine case is within the prescribed range. Pick up the probe rod and drop it to ensure that the amount of oil is in the center of the two lines, but it can not avoid excessive oil injection.
2. Weaving machine inspects the lubricating oil of turbine box, which can be visually inspected by the oil mirror. When the lubricating oil is less than half of the oil mirror, it is necessary to supplement the lubricating oil. (The supplement should not be higher than the oil lens);
3. The impeller and axle of the knitting machine should be lubricated before starting each shift and the table surface should be wiped clean to avoid foreign body sticking to the ingot.
4. Proper lubrication and maintenance of all transmission gear parts of the knitting machine;
5. Proper lubrication and maintenance of the light rod part of the photosensitive arranger of the knitting machine;
6. It is necessary to confirm that there are no obstacles in the range of motion of the knitting machine.
Seventh, tighten the screw of the transmission part and connection part of the knitting machine so as not to loosen and affect the operation of the machine.
8. Before the operation of the knitting machine, please run at a low speed for about 5 minutes before increasing the speed.

TypeInfo: Latest News

Keywords for the information:

Xuzhou Henghui Braiding Machinery Co., Ltd.-Henghui Braiding Machinery